AIRWRAP™ Safer than a cot bumper ®

The AIRWRAP is easy to fit safely. Attach the AIRWRAP following the detailed instructions provided and adjust it to suit your cot type. Please note AIRWRAP is currently suitable only for straight rail cots without fixed ends. AIRWRAP is also not recommended for rounded cots.

The AIRWRAP breathable mesh fabric has 2 sides. The soft mesh hole side faces the inside or child for both pieces.

Attach short piece to drop-side or cot front railing

1. Place inside cot with Velcro facing the railing
2. Wrap one end on the last (not corner) slat or rail
3. Fasten top and bottom Velcro evenly
4. Pull and do the same at the other end
5. Ensure bumper is centered with each side having equal lengths of Velcro attached.
6. Tighten by readjusting either end until you have desired fit
7. Fit should be just firm enough to still droop if your child was to stand on it (i.e. not support them). More important once your child can stand
8. The bottom edge of the bumper should sit just under the level of the mattress

Attach long piece to remaining three sides

1. Place inside cot with Velcro facing the railing
2. Wrap one end on the last (not corner) slat or rail nearest the drop/front rail.
3. Fasten top and bottom Velcro evenly
4. Weave through corners using option A or B (most cots will suit option A)
5. Pull and repeat steps 2 and 3 at the other end
6. Ensure bumper is centered with each side having equal lengths of Velcro attached.
7. Tighten by readjusting either end until you have desired fit
8. Fit should be just firm enough to still droop if a child was to stand on it (i.e. not support them). More important once your child can stand
9. The bottom edge of the bumper should sit just under the level of the mattress

NOTE: The final installation should appear as shown in this diagram.